Ford Mustang Service Manual: Differential Housing Cover

Rear Drive Axle and Differential

 


 



  • The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket.
  • The hypoid-design gearset consists of 8.8-inch ring gear (4209) and a drive pinion gear (4209).

    Two opposed tapered roller bearings support the drive pinion in the axle housing (4010).

  • A collapsible spacer (4662), located on the differential pinion shaft, maintains pinion bearing preload. The pinion nut (389546-S100) adjusts the preload.
  • Differential bearing shims (4067), located between the differential bearing cups (4222) and the rear axle housing, adjust the differential bearing preload and the ring gear backlash.
  • The differential case (4204) is a one-piece design with two openings to allow for assembly of the internal components and lubricant flow. Two opposed tapered roller bearings (differential bearings) (4221) support the differential case in the axle housing. Removable bearing caps (4010) retain the differential assembly in the axle housing.
  • Inside the differential case, the differential pinion shaft (4211) supports two differential pinion gears (4215). The pinion gears engage the differential side gears (4236), to which the axle shafts (4234) are splined. The differential pinion shaft lock bolt (4241) retains the differential pinion shaft in the differential case.
  • An embossed metal tag, bolted to the differential housing cover, contains rear axle identification.
    Rear Wheel Bearing and Axle Shaft Oil Seal
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The diffe ...

    Axle Housing Bushing
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The diffe ...

    Other materials:

    Installation
    Removal 1. Remove the differential assembly from the differential housing. For additional information, refer to Differential Case in this section. 2. CAUTION: Record the torque necessary to maintain rotation of the drive pinion gear through several revoluti ...

    Camber Adjustment - Rear
    Wheel Alignment Angles Camber and toe are adjustable on the front suspension systems. Front camber is adjusted by moving the top of the strut and spring assembly. Rear camber is adjusted by means of eccentric cams on the rear upper arms. Caster is preset at ...

    General operating tips
    Manual Climate Control • To reduce fog build-up on the windshield during humid weather, select Defrost. You can also improve clearing by increasing the temperature and fan speed. • To reduce humidity build-up inside the vehicle, do not drive with the syste ...