Ford Mustang Service Manual: Disassembly
Disassembly
1. Remove the differential assembly from the differential housing. For additional information, refer to Differential Case in this section.
2. Remove the 10 bolts.
3. CAUTION: Do not damage the threads in the bolt holes.
Insert a punch in the bolt holes, and drive off the ring gear.
4. Using the special tools, remove the differential bearings (4221), if necessary.
5. Remove the bolt and the differential pinion shaft (4211).
6. WARNING: Due to the spring tension, use care when removing the differential clutch spring (4214). Failure to follow these instructions may result in personal injury.
Remove the differential clutch spring.
7. Remove the differential gears.
1. Remove the two differential pinion gears (4215).
2. Remove the two differential side gears (4236).
3. Remove the two differential pinion thrust washers (4230).
8. CAUTION: Keep the differential clutch packs (4947) in order. Do not mix them.
Always reassemble them in the same sequence.
Separate the differential clutch packs and shims from the differential side gears and tag them "right" and "left".
- Clean and inspect the remaining differential components for wear and damage and install new parts as necessary.
9. CAUTION: Do not use acids or solvents when cleaning the differential clutch pack.
Wipe components only with a clean, lint-free cloth.
Clean and inspect the differential clutch packs for wear and damage and install new parts as necessary.
Differential Case and Ring Gear - Traction-Lok
Rear Drive Axle and Differential The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The diffe ...Assembly
Disassembly 1. Remove the differential assembly from the differential housing. For additional information, refer to Differential Case in this section. 2. Remove the 10 bolts. 3. CAUTION: Do not da ...Other materials:
Auxiliary input jack
WARNING: Driving while distracted can result in loss of vehicle control,
crash and injury. We strongly recommend that you use extreme caution when using
any device that may take your focus off the road. Your primary responsibility is
the safe operation o ...
Removal
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
and can ignite. Failure to follow these instructions can result in personal
in ...
Axle Housing Casting Porosity (Holes in Casting) Repair
Driveline System
Special Tool(s)
Clamp Plate
205-320 (T92L-4851-C)
Clutch Housing Alignment
Adapter
308-021 (T75L-4201-A)
Companion Flange Holding
Tool
205-126 (T78P-4851-A)
Companion Flange Runout
Gau ...