Ford Mustang (1999-2004) Service Manual: Door Window Glass Adjustment - Height Stop Adjustment

1. Close the front door.

2. Loosen the screws.

Door Window Glass Adjustment - Height Stop Adjustment

3. Raise the door window glass to the desired height.

4. Tighten the screws.

Door Window Glass Adjustment - Height Stop Adjustment

Door Window Glass Adjustment -Stabilizer

1. Raise the door window glass to the full up position.

2. Loosen the bolts.

Door Window Glass Adjustment -Stabilizer

3. Push the door window glass inner stabilizers firmly against the door window glass.

4. Tighten the bolts.

Door Window Glass Adjustment -Stabilizer

Rear Quarter Window Glass Adjustment -Convertible

1. Adjust the quarter window glass for correct fit.

1. horizontal adjustment

2. regulator plate tilt

3. glass to regulator tilt

4. front high/low up stop

5. rear high/low/tilt channel stop

6. inboard/outboard tilt

Rear Quarter Window Glass Adjustment -Convertible

    Lead Terminal Repair
    Special Tool(s) Heat Gun 107-R0300 or equivalent Material Item Specification Rear Window Defroster Repair D8AZ-19562-AA WSB-M4J58-B 1. NOTE: The rear window glass m ...

    Switch - Window Regulator Control
    Removal 1. CAUTION: Use a shop towel or similar material between the tool and the door trim panel or damage to the door trim panel may occur. Position the window regulator switch plate aside. ...

    Other materials:

    Temporary mobility kit
    Note: The temporary mobility kit sealant compound in the canister is to be used for one tire only. See your Ford authorized dealer for additional replacement sealant canisters. The kit is located in the spare tire well in the trunk. The kit consists of an ai ...

    Installation
    1. NOTE: If the oil pan is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign of wetness, or four minutes, whichever is longer. Failure to follow this ...

    Engine Coolant Temperature (ECT) Sensor - Mach I
    Material Item Specification Pipe Sealant with Teflon D8AZ-19554-A WSK-M2G350-A2 Removal and Installation 1. Remove the air intake scoop. For additional information, refer to Section. 2. Partially drain the engine cooling system. For ...