Ford Mustang (1999-2004) Service Manual: Dowels - Flywheel
Removal
1. NOTE: Take care not to damage the flywheel dowel holes or the surface areas around the flywheel dowel during removal.
Remove the flywheel dowels by using a drift pin where the flywheel dowel is installed in an open hole and a pair of locking pliers where the flywheel dowel is installed in a blind hole.
Installation
1. NOTE: Care should be taken to drive the flywheel dowel squarely into place until it is fully seated and to not damage the surrounding surface areas.
Install all flywheel dowels by driving them into place using a brass or plastic mallet.
Flywheel Runout Check
Special Tool(s) Dial Indicator/Magnetic Base 100-D002 (D78P-4201-B) or equivalent 1. Mount the special tool so that the indicator contact point rides on the clutch disc contact surf ...Dowels - Flywheel Housing to Block
Removal 1. NOTE: Take care not to damage the flywheel housing to block dowel holes or the surface areas around the flywheel housing to block dowel hole during removal. Remove the two flywheel ho ...Other materials:
Pump - CIII
Special Tool(s)
Teflon Seal Replacer Set
211-D027 (D90P-3517-A) or
equivalent
Removal and Installation
1. Remove the pulley. For additional information, refer to Pulley-CIII Pump
in this section.
2. Remove the bolt and bracket.
3. Disconn ...
Air Bag Disposal - Driver, Undeployed, Scrapped
Vehicle
Remote Deployment
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module or safety belt
retractor/pretensioner assembly. This will reduce the risk of injury in
t ...
Arm - Lower
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number or an equivalent part must be installed, if i ...