Ford Mustang (1999-2004) Service Manual: Drive Pinion Flange
Special Tool(s)
2-Jaw Puller 205-D072 (D97L-4221-A) or equivalent | |
Holding Fixture, Drive Pinion Flange 205-126 (T78P-4851-A) | |
Installer, Drive Pinion Flange 205-002 (TOOL-4858-E) or equivalent |
Stub Shaft Pilot Bearing and Seal
Special Tool(s) Remover, Bearing Cup 308-047 (T77F-1102-A) Protector, Differential Seal (Pair) 205-461 Installer, Differential Oil Seal 205-293 (T89P-4850-A) ...Removal
1. Raise and support the vehicle. 2. Remove the rear wheel and tire assemblies. 3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment. CAU ...Other materials:
Pinpoint Test M: DTC B1891 - Air Bag Tone Warning Indicator Circuit
Shorted to Battery or
Ignition
Normal Operation
The restraints control module (RCM) monitors its connection to the
generic electronic module (GEM) at
pin 10. This connection is used to signal a chime if the air bag
indicator is inoperative and another SRS
fault exists. If the RC ...
Tracing Powder
Tracing powder is used to check both the uniformity of contact and the
tension of a seal against its
sealing surface. These tests are usually done when a suspected air leak/noise
appears to originate
from the seal area or during the alignment and adjustment ...
Air Conditioning (Description and Operation)
The A/C refrigerant system is a clutch cycling orifice tube type. The system
components are:
A/C compressor (19703)
A/C clutch (2884)
A/C condenser core (19712)
A/C evaporator core (19860)
suction accumulator (19C836)
connecting refrigerant lines
The ...