Ford Mustang (1999-2004) Service Manual: Drive Pinion Flange and Drive Pinion Seal
Special Tool(s)
2-Jaw Puller 205-D072 (D97L-4221-A) or equivalent | |
Holding Fixture, Drive Pinion Flange 205-126 (T78P-4851-A) | |
Installer, Drive Pinion Flange 205-002 (TOOL-4858-E) or equivalent |
Removal
1. Raise and support the vehicle. 2. Remove the rear wheel and tire assemblies. 3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment. CAU ...Other materials:
Unique Calibration
The Emissions/CAFE/CO2 Compliance Department is responsible for assigning
these calibration
numbers. Unique calibration identifications are assigned to cover similar
vehicles to differentiate tires,
drive configurations, final drive ratios and other calibrat ...
Pinpoint Tests
PINPOINT TEST P1464: DTC P1464: A/C DEMAND OUT OF SELFTEST
RANGE
Test Step
Result / Action to Take
P14641 RECHECK FOR THE DTC
YesGO to P14642 .
No
The system is functioning
correctly. This DTC will set if the
A/C is turned on when carryi ...
Air Conditioning (A/C) System Check - Retail Procedure
NOTE: This Retail Procedure is not eligible for claiming on Ford
paid repairs (warranty and ESP).
NOTE: The engine should be run at idle for 10 minutes with the air
conditioning on and set to MAX A/C
before carrying out this retail procedure.
NOTE: Re ...