Ford Mustang Service Manual: Driveline System - General Information
Driveline Angles @ Curb Specifications
All driveshaft and pinion angles point downward.
General Specifications
a: Service refill capacities are determined by filling the axle 6.3 mm (0.25 in [1/4 in]) to 14.3 mm (0.57 in [5/16 in]) below the bottom of the filler hole. The vehicle must be on a level surface.
b: Friction Modifier
- Driveline System
- Driveline Angle
- Gear Howl and Whine
- Driveline Angle Inspection
- Axle Housing Casting Porosity (Holes in Casting) Repair
Driveline
...Driveline System
Driveline System Special Tool(s) Clamp Plate 205-320 (T92L-4851-C) Clutch Housing Alignment Adapter 308-021 (T75L-4201-A) Companion Flange Holding Tool 205 ...Other materials:
Removal
Removal
1. Remove the differential housing cover (4033) and drain the rear axle
(4001). For additional
information, refer to Differential Housing Cover in this section.
2. CAUTION: Reinstall the differential pinion shaft (4211) and the bolt in
the different ...
Crankshaft Front Oil Seal
Engine
WARNING: Do not operate the engine with the hood open until the fan
blade has been first
examined for possible cracks and separation.
The 4.6L (4V) (281 CID) is a V-8 engine with the following features:
dual overhead camshafts
four valves per cyl ...
Lamp Switch - Headlamp
Headlamps
Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and
connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
1. Verify the customer concern by operating th ...