Ford Mustang (1999-2004) Service Manual: Driveshaft

Axle Housing Casting Porosity (Holes in Casting) Repair

CAUTION: To keep the axle's sound characteristics, do not disassemble the carrier. NOTE: Casting porosity is a condition where occasionally gas bubbles will form during the casting process leaving s ...

Driveshaft (Description and Operation)

  NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material. The driveshaft has the following features ...

Other materials:

Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts. Install a new driveshaft bearing retainer circlip. 2. Remove the special tool. 3. CAUTION: Differential seal damage will occur if installing the halfshaft without the special tool installed. ...

Wheel
Removal and Installation 1. Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of the restraint system backup power supply. 2. Turn the steering wheel to the straight-ahead position and the ignition switch to ...

Principles of Operation
The vehicle has two module communications networks. The standard corporate protocol (SCP) which is an unshielded twisted pair cable (data bus plus, Circuit 914 [TN/OG] and data bus minus, Circuit 915 [PK/LB]), and the international standards organization ...