Ford Mustang Service Manual: Driveshaft (Removal and Installation)

Driveshaft (Description and Operation)

 


 

NOTE: All driveshaft assemblies are balanced. If undercoating the


NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material.

The driveshaft has the following features:

  • A tubular shaft used to transfer engine torque from the transmission output shaft to the differential in the rear axle housing, which transmits torque through the axle shafts to the drive wheels.
  • Consists of two single-cardan universal joints, a driveshaft slip yoke, a welded tube assembly and a driveshaft centering socket yoke.
  • The splined driveshaft slip yoke permits the driveshaft to move forward and rearward on the transmission output shaft during drivetrain movement and during driveshaft removal and installation.
    Universal Joints
    Driveshaft (Description and Operation)   NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material. Th ...

    Driveshaft - Cobra
    Driveshaft (Description and Operation)   NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material. Th ...

    Other materials:

    Pinpoint Tests
    Inspection and Verification NOTE: A new instrument cluster must be reconfigured. NOTE: The instrument panel dimmer switch is a part of the headlamp switch. 1. Verify the customer concern. 2. Visually inspect for obvious signs of electrical damage. Visual In ...

    Manual
    Manual WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation ...

    Disassembly
    Disassembly 1. Remove the No. 1 selective pump support thrust washer. 2. Remove the front pump support. 1. Remove the bolts. 2. Remove the front pump support. 3. Remove the seal rings. 4. Remove the inner and outer pump gerotor gears. 5. Carefully ...