Ford Mustang (1999-2004) Service Manual: Engine
A modular engine is built around four modules:
- the intake module
- the cylinder head module (RH)
- the cylinder head module (LH)
- the lower engine module
While not all repairs can take advantage of the modular concept, most out-of-vehicle repairs benefit due to the reduction of necessary time and labor.
The basic engine components consist of the following:
- single overhead camshafts
- two valves per cylinder
- sequential multiport fuel injection (SFI)
- aluminum cylinder heads (6049)
- cast iron, 90-degree V-shaped cylinder block
- individual ignition coils for each spark plug
- composite-material intake manifold
- large-bore throttle body
Engine (DIAGNOSIS AND TESTING)
For basic mechanical concerns, refer to Section. Refer to the Powertrain Control/Emissions Diagnosis (PC/ED) manual.
Engine - 4.6L (2V)
General Specifications a - With installation of a new filter. b - Distance front edge of bearing is installed below front face of cylinder block. c - Time necessary for plunger to leak down 1 ...Intake Manifold
...Other materials:
Timing Chain
Removal
1. Remove the timing cover. For additional information, refer to Engine
Front Cover in this section.
2. Remove the camshaft position sensor drive gear.
1. Remove the bolt.
2. Remove the camshaft position sensor drive gear.
3. Rotate the ...
Display mode
You can choose to turn your screen on or off and if you would like to
view the status bars on the top and bottom of the screen. Press DISP to
see the options.
Display Mode Voice Commands
The following voice commands are available in display mode.
If you are ...
Toe Adjustment - Rear
1. Loosen the nuts.
To prevent damage to the ball joints, hold the tie-rod ends while
loosening the nuts.
2. Rotate the toe link to the correct toe setting.
3. Tighten the nuts.
To prevent damage to the ball joints, hold the tie-rod ends wh ...