Ford Mustang (1999-2004) Service Manual: Engine Coolant Temperature (ECT) Sensor - 4.6L (2V)
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Partially drain the cooling system. For additional information, refer to Section.
3. Disconnect the engine coolant temperature (ECT) sensor (12A648) connector.
4. Remove the ECT sensor.
Installation
1. To install, reverse the removal procedure.
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal 1. Disconnect the battery ground cable. For additional information refer to Section. 2. Disconnect the cylinder head temperature sensor connector. 3. Remove the CHT sensor. Install ...Engine Coolant Temperature (ECT) Sensor - Cobra
Material Item Specification Pipe Sealant with Teflon D8AZ-19554-A WSK-M2G350-A2 Removal and Installation 1. Partially drain the engine cooling system. For additional informati ...Other materials:
Using voice recognition
This system helps you control many features using voice commands.
This allows you to keep your hands on the wheel and focus on what is in
front of you.
Initiating a Voice Session
Push the voice icon; a tone sounds and Listening appears in the
display. Say an ...
Retractor - Front Seat Safety Belt, Coupe
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal
1. Remove the quarter trim panel (31012). For additional information, refer
to Section.
2. Using the special tool, remove the bolt and the safety belt retractor.
Remov ...
Mass Air Flow (MAF) Sensor - 4.6L (2V)
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing
element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not
damage the sensing
element (internal to housing) or possible failure to the mass air f ...