Ford Mustang Service Manual: Engine - Mach I 4.6L (4V)
General Specifications
Engine Specifications
a - Newly Installed-Refers to the condition of the "NEW" drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.
c - P=Primary, S=Secondary, E=Exhaust.
d - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force and leak down fluid in tappet.
e - Distance front edge of bearing is installed below front face of cylinder block.
f - 0.050 Undersize-add 0.025 to standard thickness.
g - Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 101.5 mm on each side of rod centerline.
h - Cylinder Bore Diameter
Red-90.200-90.213
Blue-90.213-90.226
Yellow-90.226-90.239
i - Measured at 42 mm from piston dome, at 90 degrees to the piston pin.
j - Piston pin outer diameter is larger than piston pin bore, providing a possible interference fit.
k -Specification in 90.200 mm diameter gauge.
l -With installation of a new filter.
Drive Belt Tension
a - "Fixed" refers to systems with manually-adjusted centers which are bolted in place and considered fixed.
Torque Specifications
a - Refer to the procedure.
- Engine
- Intake Manifold - Upper
- Intake Manifold - Lower
- Valve Cover RH
- Valve Cover LH
- Crankshaft Pulley
- Crankshaft Front Oil Seal
- Engine Front Cover
- Timing Drive Components
- Valve - Springs, Retainer and Valve Stem Seal
- Hydraulic Lash Adjusters
- Roller Followers
- Camshaft
- Exhaust Manifold RH
- Exhaust Manifold LH
- Oil Filter Adapter
- Oil Level Indicator and Tube
- Oil Pan
- Crankshaft Rear Oil Seal
- Engine Mount
- Engine (Removal)
- Engine (Disassembly)
- Cylinder Head
- Piston - Pin Connecting Rod, Floating Pin
- Engine (Assembly)
- Engine (Installation)
Engine (Installation)
Engine (Description and Operation) WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) Cobra ...Engine
Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...Other materials:
Air Intake Scoop Bracket
Intake Air Distribution and Filtering - Supercharger,
Charge Air Cooler
The supercharger (SC) is a positive displacement pump. Its purpose is to
supply an excess volume of
intake air to the engine by increasing air pressure and density in the
intake man ...
Key Programming - Enable/Disable Spare Key
Programming
Anti-Theft - Passive Anti-Theft System (PATS) (Description and Operation)
The passive anti-theft system (PATS) contains the following components:
theft indicator
encoded ignition key
transceiver module
instrument cluster
powertrain control module (PCM)
...
Fuel Charging And Controls
Fuel Charging And Controls
The fuel injection supply manifold (9F792):
delivers fuel to the fuel injector.
receives fuel from the fuel supply line.
The throttle body (9E926):
controls air supply to the upper intake manifold (9424) by positioning
the th ...