Ford Mustang Owners Manual: Engine oil check

Note

: Check the level before starting the engine.

Note

: Make sure that the level is between the MIN and MAX marks.

1. Make sure that your vehicle is on level ground.

2. Turn the engine off and wait 10 minutes for the oil to drain into the oil pan.

3. Remove the dipstick and wipe it with a clean, lint-free cloth. Replace the dipstick and remove it again to check the oil level.

If the level is at the MIN mark, add oil immediately.

Adding Engine Oil

Note

: Do not remove the filler cap when the engine is running.

Note

: Do not add engine oil further than the MAX mark. Oil levels above the MAX mark may cause engine damage.

Only use oils certified for gasoline engines by the American Petroleum Institute


Only use oils certified for gasoline engines by the American Petroleum Institute (API). An oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricants Specification Advisory Council (ILSAC), comprised of U.S. and Japanese automobile manufacturers.

1. Remove the filler cap.

2. Add engine oil that meets Ford specifications. See Capacities and Specifications for more information.

3. Replace the filler cap. Turn it until you feel a strong resistance.

    Engine oil dipstick
    A. MIN B. MAX ...

    Engine coolant check
    Checking the Engine Coolant The concentration and level of engine coolant should be checked at the intervals listed in Scheduled Maintenance Information. Note: Make sure that the level is at the F ...

    Other materials:

    Final disassembly
    Disassembly Initial disassembly 1. Remove the differential housing cover (4033) and drain the lubricant into a suitable container. 2. Wipe the lubricant from the internal working parts and inspect the parts for wear and damage. 3. Using the special tool, m ...

    Installation
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes nec ...

    Connect
    Disconnect 1. Remove the A/C tube lock coupling clip (19E746), if equipped. 2. Fit the special tool to the spring lock coupling. 3. Push the tool into the cage opening to release the female fitting from the A/C tube lock coupling spring (19E576). 4. Pu ...