Ford Mustang Service Manual: Engine System - General Information
General Specifications
Engine
NOTE: This section contains information, steps and procedures that may not be specific to your engine.
This section covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the Powertrain Control/Emissions Diagnosis Manual.
The engine incorporates the following features:
- a closed positive crankcase ventilation (PCV) system.
- an exhaust emission control system.
- an evaporative emission control system.
Some engines incorporate a fail-safe cooling system. Refer to the appropriate section in Group for the procedure.
The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the scheduled Maintenance Guide.
Correct engine identification is required to order parts. Refer to the appropriate section in Group for the procedure.
For complete vehicle and engine identification codes.
- Engine (Diagnosis and Testing)
- Sprockets
- Rocker Arms - Inspection
- Push Rods - Inspection
- Camshaft Journal - Clearance, Plastigage Method
- Camshaft End Play - Push Rod Engines
- Camshaft End Play - OHC Engines
- Camshaft Lobe Lift
- Camshaft Runout
- Crankshaft Main Bearing Journal - Clearance
- Crankshaft End Play
- Crankshaft Runout
- Crankshaft - Connecting Rod Journal Taper, Out of Round
- Piston Inspection
- Piston - Pin to Bore Diameter
- Piston - Selection
- Piston - Ring End Gap
- Piston - Ring-to-Groove Clearance
- Piston - Pin Diameter
- Connecting Rod - Bushing Diameter
- Connecting Rod - Twist
- Connecting Rod - Bearing Journal Clearance
- Connecting Rod - Side Clearance
- Valve Stem to Valve Guide Clearance
- Valve Spring Strength
- Valve - Seat Inspection
- Cylinder Head - Distortion
- Cylinder Block Core Plug Replacement
- Spark Plug - Inspection
- Exhaust Manifold - Inspection
Engine
...Engine (Diagnosis and Testing)
Engine (Diagnosis and Testing) Special Tool(s) Commercially Available Leakdown Tester Quick Disconnect Compression Tester 134-R0212 or equivalent Dial Indicator Gauge ...Other materials:
Engine Component View
Engine Component View
Cylinder Heads and Valve Train Components
Engine Front Cover Components
Engine Components
Cylinder Block and Lower End Components
Engine (DIAGNOSIS AND TESTING)
Refer to Section for basic mecha ...
Water Pump - 3.8L
Engine Cooling (Description and Operation)
CAUTION: Vehicle cooling systems are filled with Motorcraft Premium
Gold Engine
Coolant VC-7-A (in Oregon VC-7-B) or equivalent meeting Ford specification
WSS-M97B51-A1
(yellow color). Always fill the cooling system ...
Starting System (Diagnosis and Testing)
Starting System (Description and Operation)
Starter Motor
The starter motor is a 12-volt unit that has the starter solenoid mounted on
the drive end housing and
functions as follows:
The current flows through the solenoid energizing coil until the
solenoi ...