Ford Mustang (1999-2004) Service Manual: Evaporative Emission Canister
Removal and Installation
1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not in large quantities, it still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel is present in the area. Failure to follow these instructions may result in personal injury.
Disconnect the battery ground cable. For additional information, refer to Section.
2. Raise and support the vehicle. For additional information, refer to Section.
3. Remove the left rear wheel. For additional information, refer to Section.
4. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or around any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
Disconnect the canister vent solenoid hose assembly.
5. Disconnect the connector.
6. Disconnect the evaporative emission (EVAP) canister purge outlet tube.
7. Remove the EVAP canister with bracket assembly from the vehicle.
- Remove the bolts.
8. Disconnect the brace.
9. Remove the canister vent solenoid and canister vent solenoid hose assembly
10. Remove the EVAP canister purge outlet tube elbow.
11. Remove the EVAP canister from the canister bracket.
12. To install, reverse the removal procedure.
- Carry out a leak test. For additional information, refer to Evaporative Emission System Leak Test in this section.
- Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair Verification Drive Cycle in this section.
Evaporative Emission Repair Verification Drive Cycle
Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool Drive Cycle Recommendations NOTE: The followi ...Evaporative Emission Canister Purge Valve
Removal and Installation 1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not in large quantities, it still presents the danger of explosion ...Other materials:
Exterior mirrors
Power Exterior Mirrors
WARNING: Do not adjust the mirror while your vehicle is in
motion.
A. Left mirror
B. Off
C. Right mirror
To adjust your mirrors:
1. Select the mirror you want to adjust.
2. Move the control in the direction you want to tilt the mirror.
...
Daytime Running Lamps (DRL) (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 97 , Daytime Running Lamps for schematic
and connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Principles of Operation
Daytime Running Lamps (DRL)
The daytime running lamp ...
Installation
1. Using the special tools, install the new intake valve stem seals.
2. Using the special tools, install the new exhaust valve stem seals.
3. Install the Valve Spring Compressor Spacer between the valve spring coils
to protect the intake
valve stem seal f ...