Ford Mustang (1999-2004) Service Manual: Exhaust Manifold RH
Special Tool(s)
Lifting Bracket, Engine 303-D088 (D93P-6001-A2) | |
Support Bar, Engine 303-290-A |
Removal and Installation
1. Install the special tool.
2. Install the special tools.
3. Raise and support the vehicle. For additional information, refer to Section.
4. Remove the LH and RH side engine mount nuts.
5. Lower the vehicle.
6. Using the special tools, raise the engine.
7. Remove the air cleaner outlet tube. For additional information, refer to Section.
8. Raise and support the vehicle.
9. Remove the starter motor. For additional information, refer to Section.
10. Separate the exhaust at the exhaust manifold. For additional information, refer to Section.
11. Remove the exhaust manifold.
1. Remove the exhaust manifold nuts.
2. Remove the exhaust manifold.
3. Remove the exhaust manifold gasket and discard.
12. NOTE: Tighten the exhaust manifold nuts in the sequence shown.
To install, reverse the removal procedure.
Camshaft
Removal and Installation 1. Remove the timing chains. For additional information, refer to Timing Drive Components in this section. 2. Remove the roller followers. For additional information, refer ...Exhaust Manifold LH
Special Tool(s) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Support Bar, Engine 303-290-A Removal and Installation 1. Install the special tool. 2. Install the speci ...Other materials:
Air Bag Disposal - Undeployed Inoperative
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module. This will
reduce the risk of injury
in the event of an accidental deployment.
WARNING: Never probe the c ...
Driveshaft (Removal and Installation)
Material
Item
Specification
Threadlock and
Sealer
E0AZ-19554-AA
WSK-M2G351-A5 (type
II)
Removal and Installation
1. Raise and support the vehicle.
2. Carry out the following:
1. Place an index mark on the rear axle pinion flange and ...
Checking MyKey system status
You can find information about your programmed MyKeys by using the
information display.
MYKEY DISTANCE
Tracks the distance when drivers use a MyKey. The only way to delete
the accumulated distance is by using an admin key to clear your MyKey.
If the distance ...