Ford Mustang (1999-2004) Service Manual: Exhaust Manifold RH
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Raise the vehicle. For additional information, refer to Section.
3. Remove the dual converter Y-pipe. For additional information, refer to Section.
4. Remove the starter. For additional information, refer to Section.
5. Remove the exhaust manifold.
1. Remove the nuts.
2. Remove the exhaust manifold.
3. Remove and discard the gasket.
6. To install, reverse the removal procedure.
- Use a new exhaust manifold gasket.
- Tighten the exhaust manifold nuts in the sequence shown.
Installation
1. NOTE: LH shown; RH similar. Install the camshafts. Lubricate the camshafts with clean engine oil. 2. Install the camshaft bearing cap assemblies and tighten the bolts in the sequence shown. ...Exhaust Manifold LH
Removal and Installation 1. Position the steering wheel straight ahead and lock the column. 2. Disconnect the battery ground cable. For additional information, refer to Section. 3. Raise the vehicl ...Other materials:
Installation
All vehicles
1. NOTE: Inspect the insulators for wear or damage. Install new
insulators if necessary.
Install the upper insulator on the spring.
2. Install the lower insulator on the lower arm.
3. Install the rear spring. Make sure the pigtail on the low ...
Component Tests
Brake Booster
1. Check the hydraulic brake system for leaks or insufficient fluid.
2. With the transmission (7003) in NEUTRAL, stop the engine (6007) and
apply the parking brake
control (2780). Apply the brake pedal several times to exhaust all
va ...
Assembly
1. Install the valve stem seals.
2. Install the valves and the valve springs.
3. CAUTION: Make sure the tool is seated correctly on the valve spring.
Apply a small
amount of air at a time. This will prevent the tool from shifting and causing
damage to
the ...