Ford Mustang (2005-2014) Owners Manual: Exterior mirrors

Power Exterior Mirrors

WARNING: Do not adjust the mirror while your vehicle is in motion.

A. Left mirror
B. Off
C. Right mirror

To adjust your mirrors:

1. Select the mirror you want to adjust.
2. Move the control in the direction you want to tilt the mirror.
3. Return the control to the center position to lock mirrors in place.

Heated Exterior Mirror (If Equipped)

The heated exterior mirrors switch on with the heated rear window.

See Heated Windows and Mirrors in the Climate Control chapter.

Pony Projection Lights (If Equipped)

Note: Moisture, frost and ice build-up (or other types of contamination) on the surface of the light lens can cause some non-permanent distortion or reduced brightness of the image. Do not use abrasive materials to clean the lens.

The lights are located on the bottom of the mirror housings.

This feature will project an image onto the ground a short distance from the vehicle whenever illuminated entry and exit is activated.

Integrated Blind Spot Mirrors (If Equipped)

WARNING: Objects in the blind spot mirror are closer than they appear.

Blind spot mirrors have an integrated convex mirror built into the upper outboard corner of the exterior mirrors. They are designed to assist you by increasing visibility along the side of your vehicle.

Check the main mirror first before a lane change, then check the blind spot mirror. If no vehicles are present in the blind spot mirror and the traffic in the adjacent lane is at a safe distance, signal that you are going to change lanes. Glance over your shoulder to verify traffic is clear, and carefully change lanes.

The image of the approaching vehicle is small and near the inboard edge of the main mirror when it is at a distance. The image becomes larger and begins to move outboard across the main mirror as the vehicle approaches (A). The image will transition from the main mirror and begin to appear in the blind spot mirror as the vehicle approaches (B). The vehicle will transition to your peripheral field of view as it leaves the blind spot mirror (C).

    Power windows
    WARNING: Do not leave children unattended in your vehicle and do not let children play with the power windows. They may seriously injure themselves. WARNING: When closing the power windows, you should ...

    Interior mirror
    WARNING: Do not adjust the mirror when your vehicle is moving. Note: Do not clean the housing or glass of any mirror with harsh abrasives, fuel or other petroleum or ammonia based cleaning products. ...

    Other materials:

    Throttle Body
    Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal in ...

    Pilot Bearing
    Special Tool(s) Puller with Slide Hammer 308-001 (T58L-101-B) 1. Remove the clutch disc and the clutch pressure plate. For additional information, refer to Disc and Pressure Plate-3.8L and 4.6L (2V) Engines or Disc and Pressure Plate-4.6L (4V ...

    Driveline Angle
      Item Description 1 Bottom of the frame 2 Engine crankshaft centerline 3 Engine angle 4 Driveshaft and coupling shaft centerline 5 Driveshaft and coupling shaft angle 6 Rear axle pinion centerline ...