Ford Mustang (1999-2004) Service Manual: Final disassembly
32. If not done previously, remove the bolts.
33. CAUTION: Do not damage the bolt hole threads.
If not done previously, insert a punch in the bolt holes and drive off the differential ring gear.
34. Using the special tools, remove the differential bearing.
- Repeat for the other side.
35. Remove the bolt and remove the differential pinion shaft (4211).
36. WARNING: The differential clutch spring (4214) is under tension. Remove the spring carefully. Failure to follow these instructions may result in personal injury.
Remove the differential clutch spring.
37. Remove the differential gears.
1. Remove the two differential pinion gears (4215) and pinion thrust washers (4230).
2. Remove the two differential side gears (4236) with the clutch packs (4947) and the shims and tag them "left" and "right."
38. CAUTION: Keep the differential clutch packs in order. Do not mix them. Always reassemble them in the same sequence.
Remove the differential clutch packs and shims from the differential side gears.
- Clean and inspect the remaining differential components for wear and damage. Install new parts as necessary.
39. CAUTION: Do not use acids or solvents when cleaning the differential clutch packs.
Wipe the components only with a clean, lint-free cloth.
Clean and inspect the differential clutch packs for wear and damage. Install new parts as necessary.
Disassembly
Initial disassembly
1. Remove the differential housing cover (4033) and drain the lubricant into
a suitable container.
2. Wipe the lubricant from the internal working parts and inspect the parts for ...
Assembly
Initial assembly
1. Coat the new differential drive pinion bearing cup(s) with lubricant.
Use SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or
equivalent
meeting Ford specificatio ...
Other materials:
Rear Spoiler
Removal and Installation
1. Open the luggage compartment lid.
2. Disconnect the high mounted stoplamp electrical connector.
3. Remove the screws and the nuts.
4. CAUTION: Use care not damge the pin-type retainers and pin-type
retainer seals
during re ...
Inspection and Verification
NOTE: Upon installation of a new GEM, the module must be
reconfigured. For additional information,
refer to Section.
1. The warning lamps are a GEM controlled system; refer to Section.
2. Verify the customer concern by operating the system in questio ...
Refrigerant System Tests
Special Tool(s)
R-134a Manifold Gauge Set
176-R032A or equivalent
1. Connect the R-134a Manifold Gauge Set. For additional information, refer
to Manifold Gauge
Set Connection in this section.
2. Adjust the climate controls for maximum cooling ...
