Ford Mustang (1999-2004) Service Manual: Fluid Pan, Gasket and Filter

Material

Item Specification
MERCON V Automatic Transmission Fluid XT-5-QM, XT-5-DM MERCON V

1. Normal maintenance requires periodic automatic transmission fluid changes. If a major repair, such as a clutch, band, bearing, etc., is required, the automatic transmission will also have to be removed for repair. At this time, the torque converter, transmission cooler and tubes must be thoroughly flushed to remove any dirt. The transmission fluid needs to be changed if evidence of fluid contamination is found. When used under continuous or severe conditions, the transmission and torque converter should be drained and refilled with fluid as specified.

2. CAUTION: Do not use any supplemental transmission fluid additives or cleaning agents. The use of these products could cause internal transmission components to fail; this will effect the operation of the transmission.

CAUTION: Use of a fluid other than specified could result in transmission failure.

Refer to the vehicle certification label affixed to the LH front door lock face panel or door pillar for the transmission code.

3. When filling a dry transmission and torque converter, refer to General Specifications chart in this section for capacity. Check the fluid level.

Transmission Fluid Drain and Refill
Special Tool(s) Automatic Transmission Flush and Fill Machine 211-00018 Automatic Transmission Flush and Fill Machine 199-00010 or equivalent Material Item Specification ...

Removal
1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Raise and support the vehicle. For additional information, refer to Section. 3. Place a drain pan under ...

Other materials:

Brake Caliper Anchor Plate
Removal 1. Remove the pads. For additional information, refer to Pads in this section. 2. Remove the anchor plate (2B292). 1. Remove and discard the anchor plate bolts. 2. Remove the anchor plate. Installation 1. CAUTION: Use correct t ...

Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal injury. 1. ...

Output Shaft
Special Tool(s) Puller, Bearing 205-D064 (D84L-1123-A) Adapter for 303-224 (Handle) 205-153 (T80T-4000-W) Installer, Output Shaft Rear Bearing 308-401 Remover/Installer, Bearing Tube 308-025 (T75L-7025 ...