Ford Mustang (1999-2004) Service Manual: Flywheel
Removal
1. Remove the clutch components. 2. Remove the bolts and the flywheel.
Installation
1. To install, reverse the removal procedure.
- Tighten the bolts in the sequence shown.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a p ...Flexplate
Removal and Installation 1. Remove the transmission. For additional information, refer to Section. 2. Remove the six bolts retaining the flexplate to crankshaft, and remove the flexplate. 3. To in ...Other materials:
Actuator - Speed Control Servo
1. CAUTION: Electronic modules are sensitive to static electrical
charges. If exposed
to these charges, damage may result.
Disconnect the battery ground cable.
2. Remove the LH wheel and tire; refer to Section.
3. Position aside the LH front splash shie ...
Glass, Frames and Mechanisms (Description and Operation)
Component Location
Windshield Glass
The windshield exterior mouldings are installed with the windshield
glass. The windshield exterior
mouldings cannot be replaced without removal of the windshield.
Window Regulator Control Switch
Power windows ...
Parking Brake Control
Removal
1. CAUTION: If any component in the parking brake system requires
repair or if the
rear axle housing (4010) is removed, the cable tension must be released.
Place the parking brake control (2780) in the released position.
2. Remove the console.
3. ...