Ford Mustang (1999-2004) Service Manual: Front Bumper Cover

Removal and Installation

NOTE: Mustang shown, GT and Cobra similar.

1. Remove the pin-type retainers and the radiator upper sight shield.

Front Bumper Cover

2. Remove the two pin-type retainers (one each side).

Front Bumper Cover

3. Remove the four front bumper cover nuts (two each side).

Front Bumper Cover

4. Remove the lower bumper cover pin-type retainers.

Front Bumper Cover

5. Remove the four headlamp mounting clips.

Front Bumper Cover

6. Disconnect the parking lamp and the headlamp electrical connectors (two each) and remove the two headlamps.

Front Bumper Cover

7. Remove the pin-type retainers.

Front Bumper Cover

8. If equipped, remove the pin-type retainers.

Front Bumper Cover

9. If equipped, disconnect the fog lamp electrical connectors.

10. Lift up on the tabs and remove the front bumper cover.

Front Bumper Cover

11. To install, reverse the removal procedure.

    Bumpers
    Torque Specifications Bumpers CAUTION: Never apply excessive heat to the bumper cover surface. Heat could cause distortion of the bumper cover. The bumper systems consist of the following components ...

    Rear Bumper Cover
    Removal and Installation 1. Remove the luggage compartment trim panel covers. 2. Remove the seven rear bumper cover nuts. 3. Remove the fuel drain hose. 4. Remove the four bumper cover screws (tw ...

    Other materials:

    Installation
    NOTE: Do not use a fiber disc to clean the surfaces. Fibers from the disc can get into the oil pan and oil and clog the oil bypass valve. 1. Clean and inspect the cylinder head for flatness. 2. Install a new head gasket on the cylinder block with the sma ...

    Parking Brake Cable Tension Release
    1. CAUTION: If any component in the parking brake system requires repair or if the rear axle housing (4010) is removed, the cable tension must be released. Place the parking brake control (2780) in the released position. 2. Remove the console. 3. W ...

    Engine Coolant Temperature (ECT) Sensor - Mach I
    Material Item Specification Pipe Sealant with Teflon D8AZ-19554-A WSK-M2G350-A2 Removal and Installation 1. Remove the air intake scoop. For additional information, refer to Section. 2. Partially drain the engine cooling system. For ...