Ford Mustang Service Manual: Front Seat Backrest

Seats (Description and Operation)

 


 

Seats - Front Power


Seats - Front Power

The front power seat features:

  • a six-way seat regulator control switch (14A701) located on the front of the seat.
  • a seat track (61705) mounted under the seat.
  • a seat regulator motor (14547) and gear housing mounted on the seat track (61705).
  • an optional power lumbar switch located on the outboard side of the seat (14C715).
  • a manual seat backrest release handle on the outboard rear corner of the seat.
  • an optional power bolster and lumbar switches located on the inboard side of the seat (Cobra only)

Seats - Power Lumbar Support

NOTE: The pump and solenoid module are serviced as an assembly with the front seat cushion frame (Cobra only). The backrest bolster/lumbar adjusting pads are serviced together and the cushion bolsters are serviced separately.

The power lumbar support system consists of:

  • seat control switch (14C715)
  • front seat backrest pad adjusting pump (65530)
  • front seat adjusting motor drive tube (618B62)
  • system wiring and circuit protection
  • front seat backrest adjusting hose (65528)
  • driver backrest and cushion bolster (Cobra)
  • driver bolster and lumbar adjusting pad pump motor and solenoid module (Cobra)
  • driver bolster and lumbar control switch (Cobra)
  • driver seat cushion adjusting hose (Cobra)

Seats - Front Seat Backrest Latch

NOTE: Under no circumstances are the front seat backrest latch components to be repaired as individual components. If a front seat backrest latch (62648) or component is non-functional or damaged, a new front seat backrest latch must be installed.

A release handle on the outboard rear corner of the seat backrest is manually operated to unlock the front seat backrest latch.

Rear Seat

The rear seat cushion pad and frame (600A88) is retained in the following manner:

  • Pins are located on the bottom front of the rear seat cushion pad and frame which secure the rear seat cushion pad and frame to the front floor pan (11135).
  • The pins are inserted into locking plates on the floor crossmember with a push button release.
  • The bottom of the rear seatback frame is retained with screws to the front floor pan.
    Front Seat Cushion
    Seats (Description and Operation)   Seats - Front Power The front power seat features: a six-way seat regulator control switch (14A701) located on the front of the seat. a seat trac ...

    Glass, Frames and Mechanisms
    WINDOW REGULATOR ELECTRIC DRIVE CURRENT DRAW General Specifications Torque Specifications ...

    Other materials:

    Transmission Case
    Manual Transmission The T56 six-speed manual transmission features the following: six forward speeds and one reverse speed. forward gears are synchronized and helical cut. a reverse gear operates through a constant-mesh, fully synchronized system. a shi ...

    Installation
    Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the engine air cleaner outlet pipe. For additional information, refer to Section. 3. Disconnect the vacuum hose and the idle air control (IAC) valv ...

    Installation
    Removal 1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold-LH in this section. 4. Remove the lower intake manifold. For additional i ...