Ford Mustang (1999-2004) Service Manual: Fuel Pressure Sensor
Material
Item | Specification |
Super Premium SAE 5W-20 Motor Oil XO-5W20-DSP or equivalent | WSS-M2C914- A |
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions may result in personal injury.
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
All engines
2. Relieve the fuel pressure. For additional information, refer to Section.
3. NOTE: The 4.6L (4V) Cobra engine is shown, the other engines are similar.
Disconnect the connector and the vacuum line.
4. Remove the bolts and the sensor.
Installation
1. Inspect the O-rings, and install new O-rings if necessary.
2. NOTE: Lubricate the new O-rings with clean engine oil to aid installation.
To install, reverse the removal procedure.
Supercharger Bypass Vacuum Solenoid
Removal and Installation
1. Remove the supercharger bypass vacuum solenoid.
1. Disconnect the vacuum hoses.
2. Disconnect the electrical connector.
3. Unclip the supercharger bypass vacuum solenoid from the vacuum accessory bracket.
2. To install, reverse the removal procedure.
Clutch Pedal Position (CPP) Switch
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Disconnect the connector. 3. Remove the bolt and the clutch pedal position (CPP) switch. In ...Other materials:
Door Alignment
NOTE: The door should be adjusted for even and parallel fit with the
body opening and surrounding
panels as well as making sure that the anti-chuck pin is not binding on
convertible models.
1. Mark the position of the front door hinges to the front ...
Power seats
WARNING: Never adjust the driver’s seat or seat back when the
vehicle is moving.
WARNING: Before returning the seat back to its original
position, make sure that cargo or any objects are not trapped
behind the seat back.
The power seat control is located
on ...
Muffler - 3.8L
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to
Section.
2. Support the rear axle with a suitable jack.
3. Remove the upper arm-to-differential bolt.
4. Remove the nut and bolt and disconnect the rear shock ...