Ford Mustang (1999-2004) Service Manual: Gear (Removal and Installation)
Special Tool(s)
Teflon Seal Replacer Set 211-D027 (D90P-3517-A) or Equivalent | |
Tie Rod End Remover 211-001 (TOOL-3290-D) |
Removal
1. Turn the steering wheel as necessary to position the wheels in the straight-ahead position. Do not lock the steering column.
2. Raise and support the vehicle.
3. Remove the front wheels and tires.
4. Remove the cotter pin and nut. Discard the cotter pin.
5. Using the special tool, disconnect the tie-rod end.
6. Rotate the steering column intermediate shaft as necessary to access the pinch bolt. Remove and discard the pinch bolt.
7. Lower the vehicle.
8. Turn the steering wheel back to the straight-ahead position. Turn the ignition key to the locked position.
9. CAUTION: Do not rotate the steering wheel when the lower steering column shaft is disconnected, or damage to the air bag sliding contact will result.
Disconnect the steering column intermediate shaft coupling (3A525).
10. Remove the nuts, washers and bolts. Position the steering gear (3504) forward.
11. Disconnect the power steering hoses. Remove and discard the seal rings.
- Plug or cap the power steering hoses and steering gear ports to prevent damage and the entry of foreign material.
12. Remove the steering gear.
Installation
1. To install, reverse the removal procedure.
- Using the special tool, install a new seal ring.
- Install a new pinch bolt.
2. Fill and leak check the power steering system.
Cooler - Fluid
Removal 1. Raise and support the vehicle. 2. Disconnect the power steering hoses. 3. Remove the bolt and routing bracket. 4. Remove the bolts and the power steering fluid cooler. Installatio ...Gear (Disassembly and Assembly)
Special Tool(s) Head Mounting Fixture 303-D041 (D83L-500-B1) or Equivalent Inner Tie Rod Socket Tool 211-D025 (D90P-3290-A) or Equivalent Steering Gear Holding Fixtur ...Other materials:
Condenser Core
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: If an A/C condenser core leak is suspected, the A/C condenser
core must be l ...
Pinpoint Test K: LFC 35/DTC B1935 - Passenger Air Bag Circuit Resistance
Low
Normal Operation
The restraints control module (RCM) monitors the resistance of the
passenger air bag ignitor by
measuring the resistance between pins 6 and 7. If the RCM detects low
resistance between these
pins, it will store a diagnostic trouble code ...
Axle information
Traction-Lokâ„¢ Axle (If Equipped)
This axle provides added traction on slippery surfaces, particularly when
one wheel is on a poor traction surface. Under normal conditions, the
Traction-Lokâ„¢ axle functions like a standard rear axle.
Extended use of other ...