Ford Mustang (1999-2004) Service Manual: Generator - 4.6L 2V
Removal and Installation
1. Disconnect the battery (10655). For additional information, refer to Section.
2. Relieve the accessory drive belt (8620) tension and remove the belt from the generator pulley.
Leave the belt in place for reinstallation. For additional information, refer to Section.
3. Remove the bolts on the upper generator bracket and remove the bracket.
4. CAUTION: This is a new style connector that has a press-to-release tab. Pulling on the tab could result in damage to the connector or harness.
Disconnect the generator electrical connections.
1. Remove the battery positive cable nut (1) and cable.
2. Disconnect the generator electrical connector.
5. Remove the lower generator bolts and remove the generator.
6. To install, reverse the removal procedure.
Generator - 3.8L
Removal and Installation 1. Disconnect the battery (10655). For additional information, refer to Section. 2. Relieve the accessory drive belt (8620) tension and remove the belt from the gen ...Generator - 4.6L 4V
Removal and Installation 1. Disconnect the battery. For additional information, refer to Section. 2. Relieve the accessory drive belt tension and remove the belt from the generator pulley. ...Other materials:
Symptom Chart
Condition
Possible Sources
Action
Dogtracking
Excessive rear
thrust angle.
Front or rear
suspension
components.
Drive axle
damaged.
CHECK the wheel alignment.
ADJUST as necessary
INSPE ...
Trim Panel - Quarter, Coupe
Removal and Installation
1. Remove the upper quarter trim panel. For additional information,
refer to Trim Panel-Upper
Quarter in this section.
2. Remove the scuff plate.
3. Remove the pin-type retainers.
4. Lower the rear seat backrests.
5. Rem ...
Switch - Door Lock
Removal
1. CAUTION: Place a rag between the window regulator switch
plate and the door trim
panel to avoid damaging the door trim panel.
Position the window regulator switch plate (14524) aside.
1. Pull at service notch.
2. Lift to release t ...