Ford Mustang (1999-2004) Service Manual: Glass, Frames and Mechanisms (Description and Operation)

Component Location

Component Location

 

Component Location

Windshield Glass

The windshield exterior mouldings are installed with the windshield glass. The windshield exterior mouldings cannot be replaced without removal of the windshield.

Window Regulator Control Switch

Power windows are standard on all models. On coupe models, only the front door window glass can be raised or lowered. The quarter window glass is fixed. On the convertible models, all four windows can be raised or lowered. On all models, the window regulator control switches are available only to the front seat passengers. There are no window regulator controls for the back seat passengers.

Quarter window glass operations are controlled by the driver window regulator control switch.

Window, One-Touch Down

The LH window one-touch down feature is activated by momentarily pressing the driver window regulator control switch to the down position. This allows the front door window glass to move downward until it is fully lowered. Momentarily pressing the window regulator control switch while the window glass is moving downward will stop the front door window glass.

Window Glass, Door

The bottom of the door window glass is mounted on a slider bracket which is part of the front door window regulator. Door window glass bracket spacers provide attachment points for the door window glass and prevent direct contact between the slider bracket and the door window glass.

Window Glass, Quarter

The rear quarter window glasses on convertible models are driven by a window regulator motor and guide assembly.

Window Glass, Rear

On the coupe, the rear window upper garnish mouldings are installed with the rear window glass. The rear window upper garnish mouldings cannot be replaced without removing the rear window glass.

    Glass, Frames and Mechanisms
    WINDOW REGULATOR ELECTRIC DRIVE CURRENT DRAW General Specifications Torque Specifications ...

    Glass, Frames and Mechanisms (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 100 , Power Windows for schematic and connector information. Refer to Wiring Diagrams Cell 56 , Rear Window Defrost for schematic and connector information. Specia ...

    Other materials:

    Pinpoint Test J: LFC 34/DTC B1934 - Driver Air Bag Circuit Resistance Low
    Normal Operation The restraints control module (RCM) monitors the resistance of the driver air bag ignitor by measuring the resistance between pins 3 and 4. If the RCM detects low resistance between these pins, it will store a diagnostic trouble code (D ...

    Installation
    All vehicles 1. NOTE: If the valve cover is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign of wetness, or four minutes, whichever is longer. Failure to ...

    Master Cylinder Priming - In-Vehicle or Bench
    WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If take ...