Ford Mustang Owners Manual: Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting control to the autolamp position.
3. Turn the lighting control to the off position.
4. Turn the ignition on.
5. Turn the ignition off.
6. Turn the lighting control to the autolamp position. The headlamps and parking lamps will turn on.
7. Turn the lighting control to the off position when the desired delay time has been reached. The headlamps and parking lamps will turn off.
You can set the headlamp exit delay to one of the following settings:
• Off
• 10 seconds
• 20 seconds
• 120 seconds
Note: You can also adjust the time delay using the display controls in the instrument cluster. See the Information Displays chapter.
Instrument lighting dimmer
• Move the control up or down to adjust the intensity of the panel lighting. • Move the control to the full upright position, past detent, to turn on the interior lamps. • Move the control down, ...Daytime running lamps
WARNING: Always remember to turn on your headlamps at dusk or during inclement weather. The Daytime Running Lamp (DRL) system does not activate the tail lamps and generally may not provide adequat ...Other materials:
Assembly
Disassembly
NOTE: The steering gear is serviceable as either a long or short rack
assembly. This procedure covers
the removal and installation of the components not supplied with a short rack
assembly. On short rack
assembly only the front wheel spindle tie- ...
Bleeding - Components
Brake System (Description and Operation)
Component Locations
+
The vehicle is equipped with a vacuum-assisted or a hydro-boost power braking
system.
The braking system is a front-to-rear split hydraulic system.
The front wheel brakes utilize a dua ...
Installation
Removal
1. Disconnect the battery negative cable.
2. Drain the engine cooling system.
3. Remove the RH exhaust manifold. For additional information, refer to Exhaust
Manifold RH in
this section.
4. Remove the lower intake manifold. For additional informa ...