Ford Mustang (1999-2004) Service Manual: Headliner
Removal
1. Remove the two upper quarter panels. For additional information, refer to Trim Panel-Upper Quarter in this section.
2. Remove the two windshield side garnish mouldings.
3. Remove the two sun visors.
1. Remove the six screws.
2. Position the sun visors aside.
- If equipped, disconnect the electrical connectors.
4. Remove the two pin-type retainers.
5. CAUTION: Folding the headliner will result in damage to the headliner.
Remove the headliner.
1. Disconnect the electrical connector.
2. Release the wiring harness locators.
3. Remove the headliner.
Installation
1. CAUTION: Folding the headliner will result in damage to the headliner.
Install the headliner.
1. Position the headliner.
- Apply Headliner Adhesive F1VY-19562-A meeting Ford specification WSSM2G355- B, to the headliner using the existing pattern.
2. Connect the electrical connector.
3. Engage the wiring harness locators.
2. Install the two pin-type retainers.
3. Install the two sun visors.
1. Position the sun visors.
- If equipped, connect the electrical connectors.
2. Install the screws.
4. Install the two windshield side garnish mouldings.
5. Install the two upper quarter trim panels. For additional information, refer to Trim Panel-Upper Quarter in this section.
Trim Panel - Package Tray
Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal and Installation 1. Remove the screw and the coat hook. 2. NOTE: Inspect the shoulder safety belt guide cov ...Exterior Trim and Ornamentation
Torque Specifications Exterior Trim and Ornamentation The exterior trim and ornamentation consists of the following components: body side scoop hood scoop (if equipped) front spoiler ...Other materials:
Key Programming - Enable/Disable Spare Key
Programming
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent
diagnostic tool
NOTE: The spare key programming switch is a diagnostic tool programmable
switch that provides the
ca ...
Transmission (Removal)
1. Disconnect the battery ground cable. For additional information, refer
to Section.
2. Lift up on the clutch pedal and secure it in place.
3. Remove the gearshift lever knob (7213).
4. Remove the console panel gearshift plate. Lift the gearshift leve ...
Deactivation Procedure
WARNING: If the supplemental restraint system (SRS) is being serviced,
the system must
be deactivated and restraint system diagnostic tools must be installed. Refer to
Air Bag
Supplemental Restraint System (SRS) in this section.
The air bag restraint system ...