Ford Mustang (2005-2014) Owners Manual: Heated windows and mirrors (if equipped)

Heated Rear Window

Note: The vehicle must be running to use this feature.

Press the control to clear the rear window of thin ice and fog. Press the control again within 15 minutes to switch it off. It turns off automatically after approximately 15 minutes, or when you switch off the ignition.

Do not use razor blades or other sharp objects to clean the inside of the rear window or to remove decals from the inside of the rear window. This may cause damage to the heated grid lines.

Your warranty does not cover this damage.

Heated Exterior Mirrors (If Equipped)

Note: Do not remove ice from the mirrors with a scraper or attempt to readjust the mirror glass that has frozen in place. These actions could cause damage to the glass and mirrors.

Note: Do not clean the housing or glass of any mirror with harsh abrasives, fuel or other petroleum-based cleaning products.

Both mirrors heat to remove ice, mist and fog when you switch on the heated rear window.

    General operating tips
    Manual Climate Control • To reduce fog build-up on the windshield during humid weather, select Defrost. You can also improve clearing by increasing the temperature and fan speed. • To reduce humid ...

    Cabin air filter
    Note: Make sure you have a cabin air filter installed at all times. This prevents foreign objects from entering the system. Running the system without a filter in place could result in degradation or ...

    Other materials:

    Belt Minder Deactivating/Activating
    Preparation 1. Before deactivating/activating the belt minder, set the parking brake. 2. Place the gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission). 3. Place the ignition switch in the OFF position. ...

    Brake System (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 60, Instrument Cluster for schematic and connector information. Refer to Wiring Diagrams Cell 97, Daytime Running Lamps for schematic and connector information. Special Tool(s) 73 Digital Multimeter 105-R0051 or Equiva ...

    Disassembly
    1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section. 2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or localizing fracture ca ...