Ford Mustang (1999-2004) Service Manual: Hydraulic Control Unit
Removal
1. Disconnect the battery ground cable(14301).
2. Disconnect the anti-lock-brake control module electrical connector.
3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction control is shown , the 4WABS without traction control system is similar with one less hydraulic line.
NOTE: Plug brake lines to prevent any brake fluid loss.
Disconnect the brake lines from the hydraulic control unit (HCU).
4. Remove the HCU bracket nuts to HCU.
5. Remove the HCU.
6. Remove the pump motor electrical connector.
7. Remove the anti-lock-brake control module screws.
8. Remove the anti-lock-brake control module from the HCU.
Installation
1. NOTE: The brake system must be bled after the HCU is installed or replaced. To install, reverse the removal procedure.
Sensor Indicator - Rear
Special Tool(s) Pinion Bearing Cone Remover 205-D002 (D79P-4621A) Axle Bearing/Seal Plate 205-090 (T75L-1165-B) Sensing Ring Replacer 206-041 (T89P-20202-A) Removal ...Module
Removal 1. Remove the hydraulic control unit (HCU). Refer to Hydraulic Control Unit . 2. Remove the pump motor electrical connector. 3. Remove the anti-lock-brake control module screws. 4. Remove th ...Other materials:
Lighting control
A. Off
B. Parking lamps, instrument panel
lamps, license plate lamps and tail
lamps
C. Headlamps
High Beams
• Push the lever toward the
instrument panel to switch
on the high beams.
• Pull the lever toward you to
switch of the high beams.
Headlamp Flashe ...
Engine (Removal)
Special Tool(s)
Special Tool(s)
Support Bracket, Engine
303-639
Spreader Bar
303-D089 (D93P-6001-A3)
Lifting Bracket Set, Engine
303-D074 (D91P-6001-A)
Removal
1. Remove the hood.
2. Remove the battery. For additi ...
Installation
All vehicles
1. NOTE: If the valve cover is not secured within four minutes, the sealant
must be removed and
the sealing area cleaned with metal surface cleaner. Allow to dry until there is
no sign of
wetness, or four minutes, whichever is longer. Failure to ...