Ford Mustang (1999-2004) Service Manual: Idle Air Control (IAC) Valve - 4.6L (2V)
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. NOTE: Discard the idle air control (IAC) valve gasket.
Remove the IAC valve.
- Disconnect the connector.
- Disconnect the hose.
- Remove the bolts, the IAC valve and the gasket.
Installation
1. To install, reverse the removal procedure.
Idle Air Control (IAC) Valve - 3.8L
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. NOTE: Discard the idle air control (IAC) valve gasket. Remove the IAC valve. Disconnec ...Idle Air Control (IAC) Valve - Cobra
Removal and Installation 1. Disconnect the idle air control (IAC) valve electrical connector. 2. Remove the bolts, the IAC valve and the gasket. 3. NOTE: Install a new gasket if necessary. To i ...Other materials:
Scheduled Maintenance
GENERAL MAINTENANCE INFORMATION
Why Maintain Your Vehicle?
Carefully following the maintenance schedule helps protect against major
repair expenses resulting from neglect or inadequate maintenance and
may help to increase the value of your vehicle when you sel ...
Switch - Window Regulator Control
Removal
1. CAUTION: Use a shop towel or similar material between the
tool and the door trim
panel or damage to the door trim panel may occur.
Position the window regulator switch plate aside.
1. Pull at the service notch.
2. Lift to release ...
Acceleration Control (Description and Operation)
Component Locations
The throttle is controlled by the accelerator cable which is connected to the
accelerator pedal and
shaft.
The accelerator pedal and shaft should travel smoothly from the idle to
the wide-open throttle
(WOT) positions. Hesi ...