Ford Mustang (1999-2004) Service Manual: Ignition Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the lower instrument panel steering column cover.
1. Remove the screws.
2. Remove the lower instrument panel steering column cover.
3. Remove the instrument panel reinforcement.
1. Remove the screws.
2. Remove the instrument panel reinforcement.
4. Disconnect the ignition switch electrical connector.
1. Loosen the bolt.
2. Disconnect the ignition switch electrical connector.
5. NOTE: Ignition switch should be in the OFF position.
Remove the ignition switch.
1. Remove the screws.
2. Remove the ignition switch.
Installation
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.
Multifunction Switch
Removal 1. Disconnect the battery ground cable. 2. Remove the ignition switch lock cylinder. 1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position. 2. ...Key Release Button
Removal 1. Disconnect the battery ground cable. 2. Remove the ignition switch lock cylinder. 1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position. 2. ...Other materials:
Warning Indicator Bulb
Removal and Installation
1. Remove the instrument cluster. Refer to Instrument Cluster in this
section.
2. Remove the necessary instrument cluster bulbs by rotating one quarter
turn counterclockwise.
3. To install, reverse the removal procedure.
...
Removal
1. Disconnect the battery ground cable. For additional information, refer
to Section.
2. Drain the engine cooling system. For additional information, refer to
Section .
3. Remove the crankshaft pulley. For additional information, refer to
Crankshaft ...
Piston Inspection
Special Tool(s)
Scraper, Piston Ring Groove
303-D033 (D81L-6002-D) or
equivalent
CAUTION: Do not use a caustic cleaning solution or a wire brush to
clean the pistons or
damage can occur.
1. Clean and inspect the (1) ring lands, (2) skirts, ...