Ford Mustang (1999-2004) Service Manual: Ignition Switch Lock Cylinder - Non-Functional
Removal and Installation
1. NOTE: Make sure the front wheels are in the straight-ahead position.
Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of the restraint system backup power supply.
2. WARNING: To avoid the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the deactivation procedure.
Deactivate the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Deactivation and Reactivation in this section.
3. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the steering wheel removal and installation procedure.
Remove the steering wheel assembly. For additional information, refer to Wheel in this section.
4. Twist off the cap from the ignition switch cylinder.
5. NOTE: The lock cylinder is repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package (F85Z-11582-AA). The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
Remove the ignition switch lock cylinder.
- Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
- Use a 3/8-inch drill bit to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
- Remove and discard the ignition switch lock cylinder and clean the drill shavings from the steering column.
6. Remove the bearing retainer.
7. Remove the bearing and gear.
- Thoroughly clean all drill shavings from the steering column and inspect it for damage.
8. To install, reverse the removal procedure.
- Install a new ignition switch lock cylinder.
- Verify ignition switch lock cylinder operation.
9. WARNING: To avoid the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the reactivation procedure.
Reactivate the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Deactivation and Reactivation in this section.
Ignition Switch Lock Cylinder - Functional
Removal and Installation 1. Disconnect the battery ground cable. 2. Remove the ignition switch lock cylinder (11582). 1. Insert the ignition key and turn to the RUN position. 2. Using a 1/8-in ...Wheel
Removal and Installation 1. Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of the restraint system backup power supply. 2. Turn the steering wheel ...Other materials:
Stub Shaft Pilot Bearing and Seal
Special Tool(s)
Remover, Bearing Cup
308-047 (T77F-1102-A)
Protector, Differential Seal
(Pair)
205-461
Installer, Differential Oil Seal
205-293 (T89P-4850-A)
Adapter for 303-224 (Handle)
205-153 (T80T-4000-W)
...
Ignition Switch Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release
...
Manual Transmission and Clutch (Diagnosis and Testing)
Inspection and Verification
It is important to get an accurate description of the concern before
any diagnosis can be carried out.
Ask questions as to whether it occurs when hot or cold, during shifting,
driving at a particular speed or
in a parti ...