Ford Mustang (1999-2004) Service Manual: Inspection and Verification
NOTE: If any concerns are noted with the speedometer, stoplamps, or horn, address those concerns by referring to their associated sections before continuing speed control diagnosis.
1. Verify the customer concern by operating the speed control system.
2. Visually inspect for obvious signs of mechanical and electrical damage.
Visual Inspection Chart
Mechanical | Electrical |
|
|
3. If the fault is not visually evident, verify the symptom and GO to the Symptom chart.
Principles of Operation
The speed control system is designed to maintain vehicle speed above 48 km/h (30 mph). After the ON switch is depressed, depressing the SET/ACCEL switch will activate the speed control servo. To inc ...Symptom Chart
NOTE: New speed control diagnostic software is available in Version 12 or higher for the diagnostic tool. When using this software, it is necessary to use Next Generation Speed Control Adapter 007- ...Other materials:
Spring Codes
The spring code portion of the vehicle certification (VC) label identifies
both the front and rear springs.
The first letter/number indicates the front spring code. The second
letter/number indicates the rear
spring code.
Front springs - base part numbe ...
Component Tests
Pressure Test
1. Turn the engine OFF.
2. WARNING: Never remove the pressure relief cap under any conditions
while the
engine is operating. Failure to follow these instructions could result in damage
to the
cooling system or engine and/or personal injury. To ...
Manual Transaxle/Transmission - TR3650
General Specifications
Torque Specifications
...