Ford Mustang (1999-2004) Service Manual: Inspection and Verification
NOTE: A new instrument cluster must be reconfigured.
NOTE: The instrument panel dimmer switch is a part of the headlamp switch.
1. Verify the customer concern.
2. Visually inspect for obvious signs of electrical damage.
Visual Inspection Chart
Electrical |
|
3. If the fault is not visually evident, determine the symptom and proceed to the Symptom Chart.
Symptom Chart
Condition | Possible Sources | Action |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Instrument Cluster and Panel Illumination (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 71 , Instrument Illumination for schematic and connector information. Special Tool(s) 73III Automotive Meter 105-R0057 or equivalent ...Pinpoint Tests
PINPOINT TEST A: THE CONTROL ILLUMINATION IS INOPERATIVE Test Step Result / Action to Take A1 CHECK PARKING LAMPS YesPlace the headlamp switch in the OFF position. GO to A2 . No ...Other materials:
Camshaft Position (CMP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the camshaft position (CMP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse t ...
Rear Subframe
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if install ...
Instrument Cluster Self-Diagnostic Mode
To enter the instrument cluster self-diagnostic mode, press and hold the
instrument cluster
SELECT/RESET button, turn the ignition switch to the RUN position, and then
continue pressing the
SELECT/RESET button (five seconds) until tESt is displayed in th ...