Ford Mustang Service Manual: Installation
Removal
Convertible
1. For removal of the back window glass, refer to Section.
Coupe
WARNING: To prevent glass splinters from entering eyes or cutting hands, wear safety glasses and heavy gloves when cutting glass from the vehicle.
2. Remove the roof side trim moulding. For additional information, refer to Section.
3. Lower the rear portion of the headliner.
4. Remove the outer lip of the moulding using a utility knife.
5. Using a soft brush or vacuum, remove any dirt or foreign material from the pinch weld.
6. CAUTION: Care must be taken to prevent scratching the pinch weld.
NOTE: Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, starting at the top center of the back window glass, cut the urethane adhesive from the glass and work down the sides.
7. Using the special tool, distance the back window glass from the body.
8. Using the special tool, cut the remaining urethane adhesive and remove the back window glass
9. Using a soft brush or vacuum, clean the pinch weld.
Removal
Removal Convertible 1. For removal of the back window glass, refer to Section. Coupe WARNING: To prevent glass splinters from entering eyes or cutting hands, wear safety glasses and heavy ...Window Glass - Door
Glass, Frames and Mechanisms (Description and Operation) Component Location Windshield Glass The windshield exterior mouldings are installed with the windshield glass. The windshield ext ...Other materials:
Side airbags
WARNING: Do not place objects or mount equipment on or near the airbag
cover, on the side of the seat backs (of the front seats), or in front seat areas
that may come into contact with a deploying airbag.
Failure to follow these instructions may increase ...
Cooling System Draining, Filling and Bleeding
Engine Cooling (Description and Operation)
CAUTION: Vehicle cooling systems are filled with Motorcraft Premium
Gold Engine
Coolant VC-7-A (in Oregon VC-7-B) or equivalent meeting Ford specification
WSS-M97B51-A1
(yellow color). Always fill the cooling system ...
Installation
Removal
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. CAUTION: Record the torque necessary to maintain rotation of the drive
pinion gear
through several revoluti ...