Ford Mustang (1999-2004) Service Manual: Installation
1. Position the side rail and install the bolts.
2. NOTE: Tighten the bottom bolt first.
Connect the mounting bracket and install the bolts.
3. NOTE: Line up the marks in the number four bow.
Tighten the bolt.
4. Connect the number two and number three bows to the side rail assembly.
5. Tighten the bolt.
6. Hand-tighten the two bolts.
7. Adjust the gap between the front of the side rail and the header to the previously recorded dimensions.
8. Tighten the bolts.
9. Connect the cable to the rear rail.
10. Attach the vinyl top cover flap to the rear rail.
11. Install the speed nut.
12. Install the headliner screws.
13. Attach the headliner pin-type retainers.
14. Install the rail seal screws.
15. Install the rail seals.
16. Install the screws and the front seal.
17. Install the speaker.
18. Install the screw.
19. Install the screw and connect the electrical connectors.
20. Position the cylinders and install the nuts.
21. Install the two cylinder rod mounting bolts.
22. Install the front safety belt retractor.
23. Install the bolts.
24. Install the side quarter trim panel.
Material
Item Specification Threadlock and Sealer E0AZ-19554-AA WSK-M2G351-A5 (type II) Shoulder Bolt Kit F5ZZ-76539A04-A - NOTE: Before starting the adjustment process, inspe ...Other materials:
Ignition Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch d ...
Checks and Services
Certain basic maintenance checks and inspections should be carried out at
specified intervals. Any
recognized adverse condition should be corrected as soon as possible.
Maximum Oil Change Interval (Normal Schedule)
8,000 km (5,000 miles) or 6 months, whiche ...
Installation
1. Position the fuel charging wiring in the vehicle and attach to the rear of
the intake manifold.
2. NOTE: Make sure the locking clips are fully engaged into the bracket.
Reposition the accelerator cable and the speed control cable (if equipped)
and ...