Ford Mustang (1999-2004) Service Manual: Installation
Lift cylinder
1. NOTE: Be sure that each fitting is installed in the correct position on the folding top hydraulic component.
NOTE: Make sure that the tetra seal is installed in the bottom of each of the folding top hydraulic cylinder ports before attaching the upper and lower hose fittings.
Install the hydraulic lines using a thread locker onto the lift cylinder.
Motor assembly
2. NOTE: Be sure that each fitting is installed in the correct position on the folding top hydraulic component.
Install the hydraulic lines using a thread locker onto the motor assembly.
Hydraulic system
3. Bleed the hydraulic system. For additional information, refer to System Bleeding in this section.
4. Install the motor and cylinders as an assembly.
5. Position the motor assembly.
6. Connect the motor electrical connector.
7. Engage the hydraulic line retainers on each side.
8. Position the lift cylinders and install the nuts.
9. Install the two cylinder rod mounting bolts.
10. Install the speakers.
11. Install the screws.
12. NOTE: This step applies to vehicles equipped with the Mach sound system.
Install the screw and connect the electrical connectors.
13. Install the rear quarter trim panel. For additional information, refer to Section.
14. Latch the convertible top.
Removal
NOTE: The convertible top hydraulic components are removed from the vehicle as an assembly. The hydraulic components are individually repaired and the system must be bled before being installed into ...Bumpers
Torque Specifications Bumpers CAUTION: Never apply excessive heat to the bumper cover surface. Heat could cause distortion of the bumper cover. The bumper systems consist of the following components ...Other materials:
USB port
WARNING: Driving while distracted can result in loss of vehicle
control, crash and injury. We strongly recommend that you use
extreme caution when using any device that may take your focus off
the road. Your primary responsibility is the safe operation of your ...
Anti-Lock Control - Traction Control (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 42, Anti-Lock Brake System for schematic and
connector information.
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
73 Di ...
Gauges And Warning Devices
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for
schematic and connector
information.
Refer to Wiring Diagrams Cell 60 , Instrument Cluster for schematic and
connector information.
Refer to Wiring Diagrams Cell 66 , Warning Chime ...