Ford Mustang (1999-2004) Service Manual: Installation
1. Install the bearing.
1. Position the knuckle on the press.
2. Using the appropriate step plate adapter, press the bearing into the knuckle until the bearing clears the snap ring groove and bottoms out in the bore.
2. Install the snap ring.
3. CAUTION: The bearing inner race must be supported during hub installation.
Failure to follow these instructions can damage the bearing.
Install the hub.
1. Position the knuckle in a press, making sure the wheel bearing inner race is supported with the appropriate step plate adapter.
2. Using the special tool, install the hub.
4. Install the dust shield and new bolts.
5. Inspect the bearing dust seal. If necessary, install a new dust seal.
6. Using a hammer and chisel, remove the dust seal.
7. Using the special tools, install the dust seal.
8. Install the knuckle. For additional information, refer to Wheel Knuckle-Cobra in this section.
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...Wheel Studs
Special Tool(s) C-Frame and Clamp Assembly 211-023 (T74P-3044-A1) Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and syst ...Other materials:
Symptom Chart
Condition
Possible Sources
Action
The Brakes Pull or
Drift
Tire air pressure.
Wheel alignment.
Brake pads.
Brake components.
Suspension
component.
Go To Pinpoint Test A .
...
Front Subframe - 3.8L Engine
Special Tool(s)
3-Bar Engine Support Kit
303-F072
Lifting Bracket Set, Engine
303-D095 (D94L-6001-A) (014-
00792)
Removal and Installation
All vehicles
1. Remove the steering gear. For additional information, refer to Section.
...
Temperature and Manifold Absolute Pressure (T-MAP)
Sensor - Cobra
Removal and Installation
1. Disconnect the temperature manifold absolute pressure (T-MAP)
sensor electrical connector.
2. Remove the bolts and the T-MAP sensor.
3. To install, reverse the removal procedure. ...