Ford Mustang (1999-2004) Service Manual: Installation
1. NOTE: Inspect the spring insulators for wear or damage. Install new spring insulators if necessary.
Make sure the spring insulators are correctly installed on the springs.
2. Install the springs.
1. Position the springs.
2. Raise the subframe using the special tool 014-00765.
3. Install new bolts.
4. Remove and discard the subframe front bolts.
5. Install new bolts and nuts. Tighten the bolts.
6. Remove the special tool 014-00765.
7. Support the lower suspension arm and bushings with jack stands.
8. CAUTION: Make sure the hardened washer is installed between the lower suspension arm and bushing and the shock absorber. Failure to do so can result in damage and failure of the lower suspension arm and bushing.
Connect the shock absorbers to the lower suspension arm and bushing and install new bolts and nuts.
9. Clip the ABS sensor wires to the subframe.
10. Install the ABS sensors and the bolts.
11. Connect the rear brake lines and install the bolts.
12. Connect the parking brake cable and conduits to the lower suspension arm and bushings and install the bolts.
13. Connect the parking brake cable and conduits to the knuckles.
14. Connect the parking brake cable and conduits to the rear brake calipers and install the clips.
15. Connect the parking brake cable and conduit to the parking brake levers.
16. Install the driveshaft.
17. Install both mufflers.
18. Install both wheel and tire assemblies.
19. Remove the jack stand from the No. 1 crossmember.
20. Bleed the brake system.
21. Check wheel alignment. Adjust if necessary.
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...Shock Absorber
Removal WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. ...Other materials:
Warning lamps and indicators
These indicators can alert you to a vehicle condition that may become
serious enough to cause expensive repairs. Many lights will illuminate
when you start your vehicle to make sure they work. If any light remains
on after starting the vehicle, refer to the re ...
Assembly
All steering gears
1. Install the steering gear in the special tools.
Steering gears equipped with travel restrictors
2. Install the travel restrictors.
Install new travel restrictors as necessary.
All steering gears
3. CAUTION: Place the steering gear at t ...
Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket.
For additional
information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the
throttle body full open
and align ...