Ford Mustang (1999-2004) Service Manual: Installation
1. Install a new upper intake manifold gasket.
2. NOTE: Refer to the location note made during removal and make sure the bolts are installed in the correct locations.
Install the upper intake manifold. Tighten the bolts in two stages in the sequence shown.
- Stage 1: Tighten to 10 Nm (89 lb-in).
- Stage 2: Rotate an additional 90 degrees (1/4 turn).
3. Connect the vacuum hose.
4. Connect the following:
- Ignition coil electrical connector.
- Radio interference capacitor electrical connector.
- Spark plug wires.
5. Connect the vacuum hoses.
6. Connect the PCV tube.
7. Connect the differential pressure feedback EGR system electrical and vacuum connections.
8. Connect the EGR vacuum regulator solenoid electrical and vacuum connections.
9. Position the accelerator cable bracket and install the bolts.
10. Connect the accelerator and speed control cables to the throttle body cam.
11. Connect the EVAP return tube and the TP sensor electrical connector.
12. Connect the vacuum hose and the IAC valve electrical connector.
13. Install the engine air cleaner outlet pipe. For additional information, refer to Section .
14. Connect the battery ground cable. For additional information, refer to Section .
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the engine air cleaner outlet pipe. For additional information, refer to Section. 3. Disconnect ...Lower Intake Manifold
Material ...Other materials:
Inspection and Verification
1. Road test.
Verify the customer's concern by performing a road test on a smooth
road.
2. Inspect tires.
Check the tire pressure with all normal loads in the vehicle and the
tires cold. For
additional information, refer to the vehicle certification ...
Brake Caliper Support Bracket
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. CAUTION: Do not allow the rear disc brake caliper (2552) to
hang from the rear
wheel brake hose (2A442)
Remove the rear disc brake caliper bolts and position the ...
Rear Disc Brake (Description and Operation)
WARNING: Brake fluid contains polyglycol ethers and polyglycols.
Avoid contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts
eyes, flush eyes with
running water for 15 minutes. Get medical attention if irritation
persist ...