Ford Mustang Service Manual: Installation

Removal

1. Disconnect the battery negative cable.

2. Drain the engine cooling system.

3. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold RH in this section.

4. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold in this section.

5. Remove the push rods. For additional information, refer to Push Rod in this section.

6. Remove the drive belt.

7. Disconnect the A/C manifold and tube assembly.

8. Disconnect the A/C compressor clutch electrical connector.

9. Remove the A/C compressor bracket.


9. Remove the A/C compressor bracket.

10. Remove the three exhaust manifold studs.


10. Remove the three exhaust manifold studs.

11. NOTE: Discard the cylinder head gasket.


11. NOTE: Discard the cylinder head gasket.

NOTE: Record the location of the long bolts and the short bolts.

Remove the cylinder head. Discard the cylinder head bolts.

Installation


    Removal
    Removal 1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold RH in this section. ...

    Oil Level Indicator and Tube
    Engine Component View Cylinder Heads and Valve Train Components   Engine Front Cover Components   Engine Components   Cylinder Block and Lower End Components   Engi ...

    Other materials:

    Removal
    Removal 1. Remove the upper intake manifold. For additional information, refer to Intake Manifold-Upper in this section. 2. Disconnect the fuel line. For additional information, refer to Section. 3. Remove the coolant by-pass tube. For additional informatio ...

    Cable and Conduit - Front
    Parking Brake (Description and Operation)   The parking brake system is cable-actuated and controlled by an independent hand-operated parking brake control (2780). To apply parking brake, pull parking brake control upward as far as possible. The par ...

    Pump and Intermediate Clutch Piston
    Transmission Description (Description and Operation) The 4R70W has the following features: Wide ratio gears Four speeds Rear wheel drive Automatic Electronic shift Torque converter clutch control Line pressure controls The transm ...