Ford Mustang (1999-2004) Service Manual: Installation
1. Install the RH engine insulator.
- Install the nuts.
- Install the bolts.
2. Install the LH engine insulator.
3. Connect the engine ground strap.
4. Install the bracket.
5. Lower the vehicle.
6. Lower the engine.
7. Raise the vehicle.
8. Install the RH engine mount nut.
9. Install the LH engine mount nut.
10. Lower the vehicle.
11. Remove the special tools.
12. Install the coolant recovery reservoir.
13. Install the radiator sight shield.
14. Install the air cleaner outlet tube.
15. Connect the battery ground cable.
Removal
1. Disconnect the battery ground cable (14301). 2. Remove the air cleaner outlet tube (9B659). 3. Remove the radiator sight shield (8C291). 4. Remove the coolant recovery reservoir (8A080). ...Engine (Removal)
Special Tool(s) Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) or equivalent Spreader Bar 303-D089 (D93P-6001-A3) or equivalent Heavy Duty Floor Crane ...Other materials:
Supercharger Belt
Removal and Installation
1. Remove the supercharger drive belt cover.
2. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
3. To install, reverse the removal procedure. ...
Push Rod
Removal
CAUTION: Mark the components removed for correct location.
1. Remove the rocker arms (6564). For additional information, refer to
Rocker Arm in this section.
2. Remove the push rods (6565).
3. Inspect the components. For additional information, ...
Toe Adjustment - Rear
1. Loosen the nuts.
To prevent damage to the ball joints, hold the tie-rod ends while
loosening the nuts.
2. Rotate the toe link to the correct toe setting.
3. Tighten the nuts.
To prevent damage to the ball joints, hold the tie-rod ends wh ...