Ford Mustang (1999-2004) Service Manual: Installation
1. Install the intake manifold and gaskets, tighten the bolts in the sequence shown.
2. NOTE: The O-ring is to be installed on the top of the thermostat.
Install the water thermostat and the O-ring.
- Install a new O-ring as necessary.
3. Install the water outlet adapter.
4. Connect the water temperature indicator sender.
5. Position the engine harness and attach to the intake manifold in two locations.
6. Connect the heater hose.
7. Install the generator.
8. Connect the electrical connector.
9. Connect the battery lead.
10. Install the generator support brace.
11. Install the ignition coils.
12. Install the fuel injection supply manifold and fuel injectors as an assembly.
13. Install four studs.
14. Position the vacuum harness and connect to the climate control vacuum supply hoses.
15. Connect the ignition coils and the fuel injectors.
16. Connect the fuel charging ground wire.
17. Connect the fuel pressure sensor electrical connector and the vacuum hose.
18. Install the throttle body and adapter as an assembly.
19. Tighten the bolts in the sequence shown.
20. Connect the throttle position sensor (TPS) electrical connector.
21. Connect the main vacuum supply to the base of the throttle body adapter.
22. Connect the idle air control (IAC) valve electrical connector.
23. Connect the vacuum hose to the EGR valve.
24. Connect the hose to the PCV valve.
25. Connect the PCV hose to the base of the throttle body assembly.
26. Connect the EGR tube to the EGR valve.
27. Install the EGR vacuum regulator solenoid bracket.
28. Connect the EGR vacuum regulator solenoid vacuum supply.
29. Connect the EGR vacuum regulator solenoid electrical connector.
30. Connect the hoses to the differential pressure feedback EGR transducer.
31. Connect the differential pressure feedback EGR electrical connector.
32. Connect the evaporative emissions return line.
33. Install the breather tube.
34. Position the cables and install the bracket.
35. Connect the accelerator cable, speed control actuator cable and the return spring.
36. Connect the upper radiator hose.
37. Connect the upper radiator hose to the water outlet adapter.
38. Connect the fuel line.
39. Install the air cleaner outlet tube.
40. Refill the engine cooling system.
Removal
1. Drain the engine cooling system. 2. Remove the air cleaner outlet tube. 3. Disconnect the fuel line. 4. Disconnect the upper radiator hose from the water outlet connector. 5. Disconnect ...Valve Cover RH
Material Item Specification Silicone Gasket and Sealant F7AZ-19554-EA or equivalent WSE-M4G323-A4 Removal and Installation 1. Remove the air cleaner outlet tube. For additional inf ...Other materials:
Removal
1. Remove the rear exterior trim mouldings.
2. Remove the clips
3. Remove the 13 Torx screws and the seal compression panel.
4. Remove the staples.
5. Remove the staples from the number one bow.
6. Remove the rear rail weatherstrip retainers from ea ...
Exhaust Gas Recirculation (EGR) Valve - Cobra
Removal and Installation
1. Disconnect the accelerator cable and the speed control cable.
2. Remove the accelerator cable bracket bolts.
3. Release the clip and position the accelerator cable bracket and the cables
aside.
4. Disconnect the electrical c ...
Transmission Draining and Filling
Material
Item
Specification
DEXRON III (ATF)
Transmission Fluid
XT-2-QDX
DEXRON III
1. Remove the drain plug and drain the transmission.
Position a suitable drain pan under the transmission.
2. Clean and install the drain plug.
3. N ...