Ford Mustang Service Manual: Installation
Removal
1. Remove the roller followers. For additional information, refer to Roller Followers in this section.
2. Remove the spark plugs. For additional information, refer to Section .
3. Position the piston of the cylinder being serviced at the bottom of the stroke.
4. CAUTION: If air pressure has forced the piston to the bottom of the cylinder any loss of air pressure will allow the valve to fall into the cylinder. If air pressure must be removed support the valve prior to removal.
Use compressed air in the cylinder to hold both valves in position.
5. Using the special tool, compress the intake valve spring.
6. NOTE
: Valve stem seals should be visually inspected if new seals are not installed.
Remove the valve spring retainer keys, the valve spring retainer, the valve spring and the valve stem seal.
7. Using the special tool, compress the exhaust valve spring.
8. NOTE
: Valve stem seals should be visually inspected if new seals are not installed.
Remove the valve spring retainer keys, the valve spring retainer, the valve spring and the valve stem seal.
Removal
Removal 1. Remove the roller followers. For additional information, refer to Roller Followers in this section. 2. Remove the spark plugs. For additional information, refer to Section . 3. Position ...Hydraulic Lash Adjusters
Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...Other materials:
Removal
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
and can ignite. Failure to follow these instructions can result in personal
in ...
Lamp Switch - Brake Pedal Position (BPP)
Headlamps
Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and
connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
1. Verify the customer concern by operating th ...
Lower Arm
Rear Suspension (Description and Operation)
Item
Part Number
Description
1
18125
Rear shock absorber
2
-
Rear axle driveline vibration damper
3
5A649
Rear lower suspension arm and bushing (common
LH and RH)
...