Ford Mustang Service Manual: Installation
Removal
Both mounts
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the coolant bypass tube. For additional information, refer to Section.
3. Rotate the drive belt tensioner clockwise and detach the drive belt from the generator pulley.
4. Disconnect the generator electrical connections.
5. Remove the bolts and the generator.
6. Install the special tool.
7. Using the special tool, support the engine.
8. Remove the front springs. For additional information, refer to Section.
9. NOTE
: RH shown, LH similar.
Remove the six splash-shield pushpins.
10. Remove the 13 bolts and the cross-brace support.
11. NOTE
: RH shown, LH similar.
Remove the two engine mount nuts.
12. Using two jackstands, support the subframe.
13. NOTE
: Mark the bolts and the crossmember location for assembly reference.
NOTE:
RH shown, LH similar.
Remove the four bolts.
14. NOTE
: RH shown, LH similar.
Remove the four bolts.
15. Using the jackstands, lower the front subframe.
RH mount
16. Remove the nut and detach the wiring harness.
17. Remove the bolts, the studbolt and the engine mount.
LH mount
18. Remove the nuts and detach the ground cables.
19. Remove the bolt, the studbolts and the engine mount.
Removal
Removal Both mounts 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the coolant bypass tube. For additional information, refer to Section. 3. Rotate ...Engine (Removal)
Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...Other materials:
Glass, Frames and Mechanisms (Description and Operation)
Glass, Frames and Mechanisms (Description and Operation)
Component Location
Windshield Glass
The windshield exterior mouldings are installed with the windshield
glass. The windshield exterior
mouldings cannot be replaced without removal of the w ...
Interior Trim and Ornamentation
General Specifications
Torque Specifications
Interior Trim
The interior trim consists of:
A-pillar lower trim panels
door trim panels
headliner (coupe)
package tray trim panel (coupe)
quarter trim panels
upper quarter trim panels (coup ...
Installation
Removal
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assemblies.
3. CAUTION: Remove the rear brake calipers to prevent drag during the
drive pinion
bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the bra ...