Ford Mustang Service Manual: Installation
Removal
1. Disconnect the electrical connectors from the EGR vacuum regulator solenoid, the supercharger bypass vacuum solenoid, and the differential pressure feedback EGR system.
2. Disconnect the vacuum hoses from the differential pressure feedback EGR system.
3. Disconnect the vacuum hoses from the supercharger bypass vacuum solenoid, and the actuator.
4. Disconnect the vacuum hoses from the EGR vacuum regulator solenoid.
5. Remove the vacuum accessory bracket mounting nut.
6. Remove the mounting bolts and the vacuum accessory bracket.
7. Remove the actuator mounting bolts.
8. Align the actuator rod with the slot in the actuator linkage, and remove the actuator.
Removal
Removal 1. Disconnect the electrical connectors from the EGR vacuum regulator solenoid, the supercharger bypass vacuum solenoid, and the differential pressure feedback EGR system. 2. Disco ...Other materials:
Disassembly
Disassembly
1. NOTE: The index mark on the output shaft must be aligned with the
index mark on the output
shaft ring gear during the assembly procedure.
Remove the ring gear snap ring.
2. Separate the ring gear and output shaft.
3. Remove the three output ...
Inspection and Verification
Inspection and Verification
CAUTION: Do not hold the steering wheel (3600) at the stops for an
extended amount of
time. Damage to the power steering pump (3A674) will result.
NOTE: Make the following preliminary checks before repairing the
steering system:
...
Engine (Installation)
Engine
A modular engine is built around four modules:
the intake module
the cylinder head module (RH)
the cylinder head module (LH)
the lower engine module
While not all repairs can take advantage of the modular conc ...