Ford Mustang (1999-2004) Service Manual: Instrument Cluster (Removal and Installation)
Removal and Installation
All vehicles
1. CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the headlamp switch knob.
- Pull out the headlamp switch knob and insert a thin tool in the slot to release the knob from the shaft.
3. Remove the screws and remove the instrument cluster finish panel.
4. Remove the screws and pull the instrument cluster forward to expose the electrical connector.
Cobra only
5. Disconnect the electrical connectors and boost pressure line and remove the instrument cluster.
Except Cobra
6. Disconnect the electrical connectors and remove the instrument cluster.
All vehicles
7. To install, reverse the removal procedure.
Warning Indicator Bulb
Removal and Installation 1. Remove the instrument cluster. Refer to Instrument Cluster in this section. 2. Remove the necessary instrument cluster bulbs by rotating one quarter turn counter ...Other materials:
Engine - 4.6L (2V)
General Specifications
a - With installation of a new filter.
b - Distance front edge of bearing is installed below front face of cylinder
block.
c - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force
and leak down fluid in
tap ...
Drive Pinion Flange
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Holding Fixture, Drive Pinion
Flange
205-126 (T78P-4851-A)
Installer, Drive Pinion Flange
205-002 (TOOL-4858-E) or
equivalent
...
System Air Flow Description
MAX A/C
When MAX A/C is selected:
The air inlet door vacuum control motor is at full vacuum, closing
off outside air and admitting
only recirculated air.
The panel/defrost door vacuum control motor is at full vacuum and
the panel/floor door vacu ...