Ford Mustang (1999-2004) Service Manual: Keyless Entry/Computer Operated Locks
Programming -Keyless Entry Remote Transmitter
NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.
NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), perform the following steps.
1. Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.
2. NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.
Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
3. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.
4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.
Inspection and Verification
1. The keyless entry system is a generic electronic module (GEM). 2. Verify the customer concern by using the remote transmitters to operate the keyless entry system. 3. Visually inspect fo ...Wipers and Washers
General Specifications Torque Specifications Wipers and Washers The wiper and washer system consists of the following components: windshield wiper mounting arm and pivot shaft pivot arms ...Other materials:
Charging System (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 12 , Charging System for schematic and
connector information.
Special Tool(s)
73III Automotive Meter
105-R0057 or equivalent
SABRE Premium Battery and
Electrical System Tester
010-00736 or equival ...
Rear seats
Rear Seat Entry and Exit
Use the seatback release to fold the
back of the front seat forward for
rear seat access. This release handle
is located on the upper back of the
front seat. The seatback locks
automatically when returned to the
normal position.
Use ...
Valve Cover - LH
Removal and Installation
1. Position the ignition wires (12281) aside.
2. Disconnect the positive crankcase ventilation (PCV) valve (6758).
3. Remove the ignition coil and position aside.
1. Disconnect the electrical connector.
2. Disconnect the ac ...